Oce VarioPrint 2090 Function Manual page 95

How to delete subsets
Press the correction key
1
behaviour.
[16] Correction key behaviour
If you press the correction
key...
One time
Two times
Three times
[16] Correction key behaviour
Select 'Yes' to delete the subset.
2
Press the correction key
3
The following message appears. 'Delete last subset?''Yes'/'No'.
Repeat step 3 until all the incorrect subsets are deleted.
4
Copy jobs
. See the table below for the correction key
Then
The number of copies is reset to one.
If the number of copies was already one,
Note:
the system resets the job settings to the default
value with just one press of the correction key.
The job settings in the four sections on the
operator panel are reset to the default value.
You delete the last subset after confirmation of
a message in a dialogue box. 'Delete last
subset?''Yes'/'No'.
again.
91