Oce VarioPrint 2090 Function Manual page 27

Sleep mode
When the system is in sleep mode, the power consumption is decreased to a
very low level. The system needs a couple of minutes to return to the stand-by
mode.
The system goes to sleep mode in the following situations.
If you do not use the Océ VarioPrint 2090 for a defined time (EPA setting).
■
To change the EPA ( Environmental Protection Agency) setting for the sleep
mode delay, change the sleep mode timer (see the Configuration and
maintenance manual See Set the EPA timers). If the Océ VarioPrint 2090 is
in the sleep mode, you must press the On/Off button
system.
Press the On/Off button
■
Then the system goes into sleep mode.
The system returns from the sleep mode in the following situations.
Press the On/Off button
■
An automatic print job (AP) arrives in the job queue.
■
If you send an automatic print job, the system remains in sleep mode in
Note:
the following situations.
- A PIN code protects the sleep mode (See Activate and change the wake-up
PIN code
- The automatic print job is forced to the mailbox (KOS, See Allow automatic
printing).
- The job queue is set to stop (KOS).
Printer warming up
The system is ready to receive and scan jobs.
Get started
. The system stops when all jobs are processed.
.
to activate the
23