Installing The Bill Acceptor System; Install The Bill Acceptor Housing Skirt And Levelers - VKI Technologies Eccellenza cafe Service Manual

Installing the Bill Acceptor System

The Eccellenza Café uses the "MDB–Level 3" protocol to communicate with a compatible
coin changer and bill acceptor. Although several coin changers and bill acceptors are
available with this protocol from different manufacturers, VKI has thoroughly tested and
validated ONLY the following coin changer units and bill acceptors for proper operation
with the Eccellenza Café:
Coin Changers
Coinco
Coinco
Bill Acceptors
Coinco
Coinco
NOTE: A bill acceptor must be installed with a coin changer in order to function.
It is highly recommended that you acquire the "Operation & Service" manuals for each of
these changers and bill acceptors from Coinco
are highly customizable and may require direct configuration through their own respective
software, which is totally independent of the Eccellenza Café software configuration. Please
note that after the changer software is configured, the machine must be switched
off and on again to recognize the changes that were made to the changer software.

Install the bill acceptor housing skirt and levelers

1. Remove the bill acceptor housing from its packaging.
2. Open the bill acceptor housing door and remove the housing's front skirt and two
levelers, which are stored inside.
3. Install the two levelers onto the bottom of the housing.
4. Install the skirt onto the bottom front of the housing and secure it in place with the
two screws provided.
August 5, 2013
Guardian 6000
® ™
Quantum 700 Series – a partially customizable 4-tube changer
® ™
MagPro MAG52BX
® ™
BillPro BP4BX / BP4SX
® ™
– a fully customizable 6-tube changer
(www.coinco.com). These sophisticated units
®
Eccellenza Café – Service Manual
89