Adjusting The Bean Grinder - VKI Technologies Eccellenza cafe Service Manual

19. Re-install the powder wall and the powder dispensers.
20. Re-install the machine's left side panel and its top panel.
21. Re-install the brewer.
22. Re-route the hot water hose under the front of the grinder and to the door spout.
23. Reconnect the service cord to the wall outlet.
24. Switch the machine power on and test the equipment operation.

Adjusting the Bean Grinder

Under normal operation, the bean grinder rarely requires adjustment. Should you need to
adjust the cutting blades, however, it can easily be done by using a flat head screwdriver or
an Allen Key (depending on the model of bean grinder in your equipment).
To make the grind finer:
1. With an Allen key (or flat screwdriver), push and only slightly turn the adjustment
screw clockwise (1/10
2. Release the pressure on the adjustment screw (stop pushing the Allen key or
screwdriver).
3. Without pushing, gently turn the Allen key or screwdriver clockwise (to tighten)
until you feel the adjustment screw click and lock (approximately 1/5
4. No more adjustments are required at this point. If the adjustment screw is tightened
further, the coffee will be ground too fine causing problems with the brewing cycle
and the beverage specifications.
To make the grind coarser, follow the same procedure, however, the adjustment screw will
need to be turned counter-clockwise instead of clockwise.
August 5, 2013
th
of a turn).
Reference:
Clockwise – Finer Grind
Counter-clockwise – Coarser Grind
Eccellenza Café – Service Manual
th
of a turn).
67