Yamaha XV1700PCRC Service Manual page 535

FUEL INJECTION SYSTEM
2 3 1
B Y
L
1. Check:
• throttle position sensor
(installed on the throttle body)
M MMM M MMM M M MMM M
a. Disconnect the throttle position sensor cou-
pler from the throttle position sensor.
b. Connect the pocket tester (Ω × 1k) to the
throttle position sensor.
Positive tester probe → blue 1
Negative tester probe → black 2
c. Measure the maximum throttle position sen-
sor resistance.
Out of specification → Replace the throttle
position sensor.
Maximum throttle position sensor
resistance
4.0 ~ 6.0 kΩ at 20 °C (68 °F)
(blue — black)
d. Connect the pocket tester (Ω × 1k) to the
throttle position sensor.
Positive tester probe → yellow 3
Negative tester probe → black 2
e. While slowly opening the throttle, check that
the throttle position sensor resistance is
within the specified range.
NOTE:
Check mainly that the resistance changes
gradually when turning the throttle, since the
readings (from closed to wide-open throttle)
may differ slightly from those specified.
Out of specification or the resistance
changes abruptly → Go to step 2 below.
Throttle position sensor
resistance
(520 ~ 900 Ω) ~ (4.0 ~ 6.0 kΩ) at
20 °C (68 °F)
(yellow — black)
L LLL L LLL L L LLL L
7 - 65
– +
ELEC
M MMM M M MMM M M MMM M MMM
L LLL L L LLL L L LLL L LLL