Installing The Crankshaft - Yamaha XV1700PCRC Service Manual

CRANKSHAFT AND CONNECTING RODS
WARNING
When the bolts are tightened more than the
specified angle, do not loosen the bolt and
then retighten it.
Replace the bolt with a new one and per-
form the procedure again.
CAUTION:
• Do not use a torque wrench to tighten the
bolt to the specified angle.
• Tighten the bolt until it is the specified
angle.
NOTE:
When using a hexagonal bolt note that the
angle from one corner to another is 60°.
L LLL L LLL L L LLL L
EAS00408

INSTALLING THE CRANKSHAFT

1. Install:
• generator shaft 1
2. Install:
• crankshaft assembly
CAUTION:
_
To avoid scratching the crankshaft and to
ease the installation procedure, lubricate
the oil seal lips with lithium-soap-based
grease and each bearing with engine oil.
NOTE:
_
• Make sure that the generator shaft drive gear
teeth and generator shaft driven gear teeth
mesh correctly.
• Align the right connecting rod with the front
cylinder sleeve hole.
5 - 118
ENG
L LLL L L LLL L L LLL L LLL