Yamaha XV1700PCRC Service Manual page 130

Ë Fasten the decompression solenoid lead, speed sensor lead, cylinder identification sensor lead, sidestand
switch lead, crankshaft position sensor lead, neutral switch lead, and fuel pump lead with a plastic band.
Ì Position the gray mark on the starter motor lead at the center of the bolt. Fit the starter motor lead and sid-
estand switch lead into the groove in the frame, and then fasten them with a plastic locking tie.
Í 10
~ ~
30 mm (0.4 1.2 in)
È
Ë
3
2
É
1
Ê
A-A
2 - 42
CABLE ROUTING
B
Ì 3
SPEC
A A
4
Í
B