Yamaha XV1700PCRC Service Manual page 502

STARTER MOTOR
4. Measure:
• armature assembly resistances (commuta-
tor and insulation)
Out of specification → Replace the starter
motor.
M MMM M MMM M M MMM M
a. Measure the armature assembly resis-
tances with the pocket tester.
Pocket tester
YU-03112
Armature coil
Commutator resistance 1
0.0081 ~ 0.0099 Ω at
20 °C (68 °F)
Insulation resistance 2
Above 1 MΩ at 20 °C (68 °F)
b. If any resistance is out of specification,
replace the starter motor.
L LLL L LLL L L LLL L
5. Measure:
• brush length a
Out of specification → Replace the brushes
as a set.
Brush length wear limit
5 mm (0.2 in)
6. Measure:
• brush spring force
Out of specification → Replace the brush
springs as a set.
Brush spring force
7.36 ~ 11.04 N (736 ~ 1,104 gf)
7. Check:
• gear teeth
Damage/wear → Replace the gear.
8. Check:
• bearing
• oil seal
Damage/wear → Replace the defective
part(s).
7 - 32
– +
ELEC
M MMM M M MMM M M MMM M MMM
L LLL L L LLL L L LLL L LLL