STARTER MOTOR
EAS00770
CHECKING THE STARTER MOTOR
1. Check:
• commutator
Dirt → Clean with 600 grit sandpaper.
2. Measure:
• commutator diameter a
Out of specification → Replace the starter
motor.
Commutator wear limit
27.5 mm (1.08 in)
3. Measure:
• mica undercut a
Out of specification → Scrape the mica to
the proper measurement with a hacksaw
blade that has been grounded to fit the
commutator.
Mica undercut
1.5 mm (0.06 in)
NOTE:
_
The mica of the commutator must be undercut
to ensure proper operation of the commutator.
7 - 31
–
+
ELEC