Removing The Primary Drive Gear; Checking The Friction Plates; Checking The Clutch Plates - Yamaha XV1700PCRC Service Manual

CLUTCH
EAS00279

REMOVING THE PRIMARY DRIVE GEAR

1. Remove:
• crankshaft position sensor rotor bolt 1
NOTE:
_
While holding the generator rotor 2 with the
sheave holder 3, loosen the crankshaft posi-
tion sensor rotor bolt.
Primary sheave holder
YS-01880-A
EAS00280

CHECKING THE FRICTION PLATES

The following procedure applies to all of the
friction plates.
1. Check:
• friction plate
Damage/wear → Replace the friction plates
as a set.
2. Measure:
• friction plate thickness
Out of specification → Replace the friction
plates as a set.
NOTE:
_
Measure the friction plate at four places.
Friction plate thickness
2.9 ~ 3.1 mm (0.114 ~ 0.122 in)
EAS00281

CHECKING THE CLUTCH PLATES

The following procedure applies to all of the
clutch plates.
1. Check:
• clutch plate
Damage → Replace the clutch plates as a
set.
5 - 62
ENG