Table of Contents
Advertisement
Removal
1. Raise the vehicle and support it with suitable safety
stands.
2. Remove wheel and tire assembly as necessary.
3. Clean dirt, grease, and other foreign material off the
pipe fittings at both ends.
4. Remove brake pipe (1).
5. Remove plastic clip (2).
POWER ASSISTED BRAKE SYSTEM
Brake Pipe
Installation
To install, follow the removal steps in the reverse order,
noting the following points:
1. Tighten the brake pipes to the specified torque.
Master cylinder side
Torque: 12 N·m (104 lb in)
Other
Torque: 16 N·m (12 lb ft)
After installing the brake pipes, bleed the brakes as
described in this section.
330RW001
330RW002
5C–13
Hide quick links:
Advertisement
Table of Contents
