5C–44 POWER ASSISTED BRAKE SYSTEM
Brake Pads Inspection
Check the outer pads by looking at each caliper from
above. Check the thickness on the inner pad by looking
down through the inspection hole in the top of the caliper.
Whenever the pad is worn to about the thickness of the
pad base, the pad should be removed for further
measurements. The pad should be replaced anytime the
pad thickness (1) is worn to within 1.0 mm (0.039 in) of the
pad itself.
The disc pads have a wear indicator that makes a noise
when the pad wears to where replacement is required.
Minimum limit (1): 1.0 mm (0.039 in)
Brake Pads and Associated Parts
Legend
(1) Caliper Assembly
(2) Clip
Rear Disc Brake Pads
(3) Lock Bolt
(4) Pad Assembly
302RW016
306RW001