System Inspection - Isuzu Trooper 1999 Workshop Manual

CAUTION:
f Never use the air bag assembly from another
vehicle. Use only the air bag assembly for "UX".
f The driver's air bag assembly (Inflator module)
for 1999 model has different characteristic to the
parts for 1998 model.
When replace the driver's air bag assembly,
confirm the parts number and use only the parts
for 1999 model. (The driver's air bag assembly for
1999 model has "yellow" bar codes label. 1998
model has "white" bar codes label.)
NOTE: Pass the lead wire through the tabs on the plastic
cover (wire protector) of inflator to prevent lead wire from
being pinched.
16. Secure the module with one bolt to relieve weight on
the wire connector.
17. Tighten bolts to specified sequence as illustrated.
Torque: 8 N·m (69 lb in)
18. Install driver knee bolster (reinforcement).
19. Install steering lower cover.
20. Install the engine hood opening lever.
21. Install lower cluster assembly.
22. Connect the wiring harness connectors then install
front console assembly.
23. Install the transmission (for M/T) and transfer control
lever knob.
24. Connect the yellow 2-way SRS connector located
under the steering column.
25. Connect the battery "–" terminal cable.

System Inspection

Turn the ignition switch "ON" while watching warning light.
The light should flash 7 times and then go off. If lamp does
not operate correctly, refer to Restraints section.
POWER ASSISTED SYSTEM
827RW003
2A–63