Toe-In Adjustment - Isuzu Trooper 1999 Workshop Manual

Toe-in Adjustment

1. To adjust the toe-in angle, loosen the lock nuts(2) on
the outer track rods(1) and turn the outer track rods.
Turn both rods the same amount, to keep the steering
wheel centered .
Toe-in: 0 2 mm (0
2. Tighten the lock nut to the specified torque.
Torque: 118 N·m (87 lb ft)
Maximum Steering Angle Adjustment
The maximum steering angle of the front wheels can be
adjusted with the stop bolts under the frame side
members.
1. Position each front wheel on the turning radius gauge
in a straight-ahead position.
2. Set the parking brake firmly.
0.08 in)
433RS001
433RS002
POWER ASSISTED SYSTEM
3. Adjust the inside wheel angle of each side with the
stop bolts.
NOTE: The maximum protruding length(1) of stop bolt(3)
from the lock nut(2) should be 10 mm or less
4. Similarly adjust the inside wheel angle of the other
side with stop bolt.
Inside wheel: 34° (+0° to –2°)
Outside wheel: 32°
NOTE: Maximum steering angles should be set after
adjusting front wheel alignment.
5. If the stop between the lower link end and the knuckle
comes ahead of the stop bolt, adjust the stop bolt so
that inner stop bolt touches the drop arm (relay lever).
6. Tighten the lock nut to the specified torque.
Torque: 23 N·m (17 lb ft)
2A–17
433RS003
433RS004