Table of Contents
Advertisement
4B2–88
DRIVE LINE CONTROL SYSTEM (TOD)
Step
13
1. Apply the brake and fully turn the steering to the left (or right)
end, and start the creep run.
Does the voltage between terminals 4 and 20 range between 0.1
and 1.0V?
14
1. Shift the transfer lever to the high (TOD) position.
2. Fully turn the steering to the left (or right) end, and select the D
range and start the creep run.
Does the voltage between terminals 4 and 20 range between 0.1
and 1.0V?
15
1. Select the 4WD SW to the 2WD position.
2. Jack up the right front wheel.
Does the front tire rotate smoothly?
16
Check that all the parts are mounted.
Is this step complete?
*NOTE: Before checking this item, run the vehicle more
than 10 meters with the steering wheel in straight position
so that the 4L mechanical lock sleeve can be released
certainly.
Action
Yes
Repair the
The ECU has
transfer
failed. Replace
assembly.
the ECU.
Go to Step 16
Go to Step 16
Go to Step 15
Go to Step 13
The phenomenon
reproduced.
Repair the
"Troubles
intermittently
transfer
assembly.
observed".
Go to Step 16
Go to Step 16
Repeat the "Fault
Return to Step 16
Diagnosis Flow".
No
is not
Refer to
Hide quick links:
Advertisement
Table of Contents
