Isuzu Trooper 1999 Workshop Manual page 716

6A–74 ENGINE MECHANICAL
Legend
(1) Around Bolt Holes
(2) Around Dowel Pin
 Apply engine oil to the oil seal lip.
 Align the cylinder block dowel pin holes with the rear
retainer dowel pins.
 Tighten the rear retainer fixing bolts. New bolts
should be used when installing rear retainer.
Torque: 18 N·m (13 lb ft)
NOTE: Be very careful not to disengage the oil seal garter
spring during installation of the rear retainer.
If the seal was removed from retainer for
replacement, apply engine oil to the oil seal lip and
install the oil seal using J–39201 oil seal installer.
015RW002
3. Flywheel (9)
1. Thoroughly clean and remove the oil from the
threads of crankshaft.
2. Remove the oil from the crankshaft and flywheel
mounting faces.
3. Mount the flywheel on the crankshaft and then
install the washer.
4. Hold the crankshaft to prevent from rotating then
install the bolts in the order shown to the specified
torque.
Torque: 54 N·m (40 lb ft)
NOTE: Do not reuse the bolt and do not apply oil or thread
lock to the bolt.
015RW001
015RS017
015RS018