Camber Adjustment - Isuzu Trooper 1999 Workshop Manual

2A–16 POWER ASSISTED SYSTEM
Tighten the fulcrum pin bolt to the specified torque.
Torque: 152 N·m (112 lb ft)

Camber Adjustment

The camber angle can be adjusted by means of the
camber shims(2) installed in position between the chassis
frame(1) and fulcrum pins
Camber angle: 0° 30'
King pin inclination: 12°30'
CAUTION: Left and right side must be equal within
30'.
Caster shim Caster shim
Camber shim Camber shim
30'
450RS004
Position of shims
Front side
When added When removed
When removed When added
— When removed
— When added
When added
When removed
NOTE: Overall thickness of caster shim and camber
shim should be 10.8 mm (0.425 in) or less.
Tighten the fulcrum pin bolt to the specified torque.
Torque: 152 N·m (112 lb ft)
Camber angle Camber angle
Rear side
Decreases
Increases
Unchanged
Unchanged
Decreases
Increases
450RS005
Caster angle Caster angle
Decreases
Increases
Decreases
Increases
Unchanged
Unchanged