Installation - Isuzu Trooper 1999 Workshop Manual

DIFFERENTIAL (REAR)
4A2–12

Installation

1. Clean the contact surfaces of the axle and differential
carrier. As shown in the drawing, apply Three Bond
TB1215 or equivalent then install differential
assembly.
2. Install bolt and nut. Tighten the differential carrier
mounting bolts and nuts to the specified torque.
Torque:Nuts 44N·m (33lb ft)
Bolts 66N·m (48lb ft)
3. Install axle shaft assembly. Be sure not to damage
the oil seal by axle shaft.
4. Install nut, refer to Axle Shaft in this section.
5. Install parking brake cable, refer to Parking Brakes in
Brake section.
NOTE: After completing the assembling work, fill the
prescribed gear oil to the filler hole.
Lubricant capacity: 3.0 liter (3.2 US qt)
6. Tighten the oil filler plug to the specified torque.
Torque: 78N·m (58lb ft)
425RS006