2A–40 POWER ASSISTED SYSTEM
3. Remove stabilizer bar bolt and nut and push the
stabilizer bar aside, then remove the relay lever bolts
and nuts.
4. Remove relay lever and bracket.
5. Remove relay lever nut and washer.
6. Remove relay lever, use remover J–22912–01 to
remove relay lever from the bracket.
7. Remove bracket.
Installation
1. Install bracket.
2. Install relay lever.
3. Install nut and washer and tighten the nut to the
specified torque.
Torque: 118 N·m (87 lb ft)
4. Install relay lever and bracket.
5. Install bolt and nut and tighten it to the specified
torque.
Torque: 44 N·m (33 lb ft)
6. Install nut and cotter pin and tighten the nut to the
specified torque, with just enough additional torque to
align cotter pin holes. Install new cotter pin.
Torque: 59 N·m (43 lb ft)
433RS018
433RS019