Inspection And Repair; Bushing Replacement - Isuzu Trooper 1999 Workshop Manual

8. Using snap ring pliers, remove the snap ring (1)
fastening the ball retainer to the center shaft.
9. Remove ball retainer, ball guide and bellows.
10. Raise the hooked end of the band (1) with a
screwdriver or equivalent.
11. Remove band.
12. Remove bellows.
13. Remove dust seal.
14. Remove BJ shaft assembly.
15. Remove the mounting bracket fixing bolts, and then
remove DOJ case assembly from the axle case.
16. Remove snap ring and bearing.
17. Remove snap ring and oil seal.
18. Remove bracket.

Inspection and Repair

Make necessary correction or parts replacement if wear,
damage, corrosion or any other abnormal conditions are
found through inspection.
Check the following parts:
1. Drive shaft joint assembly
2. DOJ case, ball, ball guide, ball retainer
3. Bellows
4. Bearing
5. Dust seal, oil seal

Bushing Replacement

f Remove the bushings using a remover J–39378–1
and hammer.
412RS013
f By using installer J–39378–2 and base J–39378–3,
press fit the bushings into the bracket.
412RS014
DRIVE SHAFT SYSTEM
4C–13
412RS015
412RS016