Displaying Management Module Cpu Usage; Removing Mac Address Entries - Brocade Communications Systems FESX624HF Installation Manual

Managing the FastIron Compact Switch

Displaying management module CPU usage

Brocade>show chassis
power supply 1 present, status ok
power supply 2 not present
fan 1 ok
Fan 1 speed: slow<->[[medium]]<->fast
fan 2 ok
Fan 2 speed: slow<->[[medium]]<->fast
fan speed switching temperature thresholds:
slow -> medium @ 30 degrees Celsius
slow <- medium @ 25 degrees Celsius
medium -> fast @ 40 degrees Celsius
medium <- fast @ 35 degrees Celsius
Exhaust Side Temperature Readings:
Current temperature : 35.5 degrees Celsius
Warning level.......: 64.0 degrees Celsius
Shutdown level......: 80.0 degrees Celsius
Intake Side Temperature Readings:
Current temperature : 29.0 degrees Celsius
Boot Prom MAC: 00e0.5200.0100
Displaying management module CPU usage
You can display the amount of the management module's CPU in use. To do so, enter the following command at any level of the CLI.
Brocade#show cpu
31 percent busy, from 3248 sec ago
1 sec avg: 31 percent busy
5 sec avg: 31 percent busy
60 sec avg: 31 percent busy
300 sec avg: 31 percent busy
Syntax: show cpu

Removing MAC address entries

You can remove learned MAC address entries from the Brocade system's MAC address table. You can remove the following:
•
All MAC address entries.
•
All MAC address entries for a specified interface module.
•
All MAC address entries for a specified Ethernet port.
•
All MAC address entries for a specified VLAN.
•
A specified MAC address entry in all VLANs.
For example, to remove entries for the MAC address 000d.cb80.00d in all VLANs, enter the following command at the Privileged EXEC
level of the CLI.
Brocade# clear mac-address 000d.cb80.00d0
Syntax: clear mac-address <mac-address> | ethernet <port-num> | vlan <number>
If you enter the clear mac-address command without any parameters, the software removes all MAC entries.
58 Brocade FastIron Edge X-Series Hardware Installation Guide
Part Number: 53-1002499-02