Table of Contents
Advertisement
10
TUNING THE CHASSIS
10.13
Adjusting the rebound damping of the fork
Info
The hydraulic rebound damping determines the fork suspension behavior.
10.14
Handlebar position
10.15
Adjusting the handlebar position
Info
Turn clockwise to increase damping; turn counterclockwise to reduce damp-
ing.
–
Turn the red adjusting screw
Info
Adjusting screw
The rebound damping is located in the right fork leg (red adjusting screw).
The compression damping is located in the left fork leg (white adjusting
screw).
–
Turn counterclockwise by the number of clicks corresponding to the fork type.
Guideline
M00244-11
Rebound damping
Comfort
Standard
Sport
Info
Turn clockwise to increase damping; turn counterclockwise to reduce damp-
ing.
On the upper triple clamp, there are two holes at a distance of
Hole distance A
The holes on the handlebar support are placed at a distance of
Hole distance B
The handlebar can be mounted in four different positions. In this way, the handlebar can
be mounted in the position that is most comfortable for the rider.
800116-10
–
Remove screws
to one side.
Info
Protect the components against damage by covering them.
Do not bend the cables and lines.
–
Remove screws
–
Place the handlebar support in the required position. Mount and tighten screws
B00375-10
Guideline
Screw, handlebar support
Info
Position the left and right handlebar supports evenly.
all the way clockwise.
is located at the upper end of the right fork leg.
17 clicks
15 clicks
13 clicks
15 mm (0.59 in)
3.5 mm (0.138 in)
. Take off the handlebar clamps. Take off the handlebar and lay it
. Remove the handlebar support.
M10
to each other.
from the center.
40 Nm
Loctite
®
243™
(29.5 lbf ft)
31
.
Advertisement
Table of Contents
