Debug Platform Cli-Redirection Main - Cisco Catalyst 3120 Command Reference Manual

debug platform cli-redirection main

debug platform cli-redirection main
Use the debug platform cli-redirection main privileged EXEC command to enable debugging of the
main (important) command-line interface (CLI) redirection events. Use the no form of this command to
disable debugging.
Syntax Description
This command has no arguments or keywords.
Defaults
Debugging is disabled.
Command Modes
Privileged EXEC
Command History Release
12.2(40)EX
Usage Guidelines
The undebug platform cli-redirection main command is the same as the no debug platform
cli-redirection main command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member. You
also can use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
Related Commands Command
show debugging
Cisco Catalyst Blade Switch 3120 for HP Command Reference
B-26
debug platform cli-redirection main
no debug platform cli-redirection main
Modification
This command was introduced.
Description
Displays information about the types of debugging that are enabled.
Appendix B Cisco Catalyst Blade Switch 3120 for HP Debug Commands
OL-12248-01