Installing The Switch - Seagull Models Extra 260 Assembly Manual

1) Slide the fiberglass cowl over the en-
gine and line up the back edge of the cowl with
the marks you made on the fuselage then trim
and cut.
3x10mm.
Trim and cut.
Trim and cut.
2) While keeping the back edge of the
cowl flush with the marks, align the front of
the cowl with the crankshaft of the engine. The
front of the cowl should be positioned so the
crankshaft is in nearly the middle of the cowl
opening. Use the spinner backplate as a guide.
Hold the cowl firmly in place using pieces of
masking tape.
www.seagullmodels.com
and secure it in place using four 3 x 10mm
wood screws. See picture below.
onto the engine and make the cutout in the
cowl for muffler clearance. Connect the fuel
and pressure lines to the carburetor, muffler
and fuel filler valve.
side of the fuselage.
1.5mm wire
(needle valve).
3) Slide the cowl back over the engine
4) Install the muffler and muffler extension
3x10mm(4pcs).

INSTALLING THE SWITCH.

Install the switch into the precut hole in the
Remove covering.
11