Installing The Fuselage Servos; Mounting The Engine; Installing The Switch - Seagull Models GISPY MOTH Assembly Manual

GISPY MOTH.
Blow through one of the lines to en-
sure the fuel lines have not become kinked
inside the fuel tank compartment. Air
should flow through easily.

INSTALLING THE FUSELAGE SERVOS.

Because the size of servos differ, you
may need to adjust the size of the precut open-
ing in the mount. The notch in the sides of the
mount allow the servo lead to pass through.
1) Install the rubber grommets and brass
collets onto the throttle servo. Test fit the servo
into the aileron servo mount.
2) Secure the servos with the screws pro-
vided with your radio system.
Elevator servo.
Rudder servo.
Elevator servo.
THROTTLE SERVO ARM INSTALLATION.
Install adjustable servo connector in the servo
arm as same as picture below:
Loctite secure.
1 PCS.
Elevator servo arm.
Rudder servo arm.
Elevator servo arm.

INSTALLING THE SWITCH.

Install the switch into the precut hole in the
side, in the fuselage.
8
Throttle servo.
Adjustable Servo
connector.
Servo arm.
Throttle servo arm.
Instruction Manual.

MOUNTING THE ENGINE.

1) Position the engine with the drive washer
(140mm) forward of the firewall as shown.
140mm.
2) Use a pin drill and 4mm drill bit to drill a
small indentation in the mount for the engine
mounting screw.
3/ 32" Hole.
Trim and cut.
Switch.