Installing The Fuselage Servos; Installing The Switch - Seagull Models GLASAIR Sportsman GS-2 Assembly Manual

Blow through one of the lines to en-
sure the fuel lines have not become kinked
inside the fuel tank compartment. Air
should flow through easily.

INSTALLING THE FUSELAGE SERVOS.

Because the size of servos differ, you
may need to adjust the size of the precut open-
ing in the mount. The notch in the sides of the
mount allow the servo lead to pass through.
1) Install the rubber grommets and brass
collets onto the throttle servo. Test fit the servo
into the aileron servo mount.
2) Secure the servos with the screws pro-
vided with your radio system.
Rudder servo.
Elevator servo.
THROTTLE SERVO ARM INSTALLATION.
Install adjustable servo connector in the servo
arm as same as picture below:
www.seagullmodels.com
Throttle servo.
Tailwheel servo.
Loctite secure.
1 PCS.
Rudder servo arm.
Elevator servo arm.

INSTALLING THE SWITCH.

Install the switch into the precut hole in the
side, in the fuselage.
Recomend mounting switch inside fuselage if
using floats.
Cut Covering.
Adjustable Servo
connector.
Servo arm.
Throttle servo arm.
Tailwheel servo arm.
3/ 32" Hole.
7