Installing The Switch; Installing The Spinner - Seagull Models SEA12 Assembly Manual

PC-9

INSTALLING THE SPINNER.

Install the spinner backplate, propeller
and spinner cone. The spinner cone is held in
place using two 3mm x 12mm wood screws.
The propeller should not touch any part
of the spinner cone. If it does, use a
sharp modeling knife and carefully trim away
the spinner cone where the propeller comes
in contact with it.
Instruction Manual.

INSTALLING THE SWITCH.

1) Install the switch into the precut hole
in the servo tray, in the fuselage, from the bot-
tom. Use the two screws provided with the
switch to secure it in place. Drill two 3/32"
holes through the tray for the screws to pass
through.
2) Using a 3/32" drill bit, drill a hole
through the side of the fuselage, opposite the
muffler, even with the switch.
3) Make a push-pull lever out of scrap
wire. Attach the wire to the switch lever and
route the wire out the side of the fuselage,
through the hole you drilled.
Some switches come with a hole drilled
through the switch tab for this very pur-
pose. If your switch does not, remove the
switch and drill a 3/32" hole through the middle
of the switch tab.
17