Yamaha XJR1300(L) 99 Service Manual page 49

Clutch hose
1
Starter cable
2
Air filter case drain hose
3
4 Frame ground
Flasher relay connector
5
Oil light relay connector
6
Igniter unit connectors
7
Starter motor
8
AC generator
9
Sidestand switch
10
Sidestand switch lead
11
Ignition coil lead (#1, 4)
12
CABLE ROUTING
A Insert the plastic band through
the hole of plastic panel and then
fasten the clutch hose with it.
Make sure that the end of band
inside of motorcycle.
B To headlight lower hole.
C Route the wireharness and start-
er cable through the guide.
D Connect the ignition lead with
white marking tape to the ignition
coil (#1, 4).
2-29
SPEC
E Fasten the high tension cables
(#1, 2) with a plastic clamp. Posi-
tion the clamp at 50 – 80 mm
above the high tension cable
number.
F Fasten the horn lead to the frame
with a plastic band. Make sure
that the end of band down ward.
G Install the frame ground and ig-
niter unit together with screw.