VALVES AND VALVE SPRINGS
EAS00237
REMOVING THE VALVES
The following procedure applies to all of the
valves and related components.
NOTE:
Before removing the internal parts of the cylin-
der head (e.g., valves, valve springs, valve
seats), make sure that the valves properly seal.
1. Remove:
S valve lifter 1
S valve pad 2
NOTE:
Make a note of the position of each valve lifter
and valve pad so that they can be reinstalled in
their original place.
2. Check:
S valve sealing
a. Pour a clean solvent 1 into the intake and
b. Check that the valves properly seal.
3. Remove:
S valve cotters 1
NOTE:
Remove the valve cotters by compressing the
valve spring with the valve spring compressor
2 .
4-19
Leakage at the valve seat ! Check the valve
face, valve seat, and valve seat width.
Refer to "CHECKING THE VALVE SEATS".
exhaust ports.
There should be no leakage at the valve seat
2 .
Valve spring compressor
90890-04019
ENG