Yamaha XJR1300(L) 99 Service Manual page 240

FRONT AND REAR BRAKES
EAS00598
ASSEMBLING
FRONT BRAKE MASTER CYLINDER
WARNING
S Before installation, all internal brake com-
ponents should be cleaned and lubricated
with clean or new brake fluid.
S Never use solvents on internal brake com-
ponents.
1. Install:
S brake master cylinder 1
NOTE:
S Install the brake master cylinder holder with
the "UP" mark facing up.
S Align the end of the brake master cylinder
holder with the punch mark a on the handle-
bar.
S First, tighten the upper bolt, then the lower bolt.
2. Install:
S copper washers (New) 1
S brake hose 2
S union bolt 3
WARNING
Proper brake hose routing is essential to in-
sure safe motorcycle operation. Refer to
"CABLE ROUTING".
CAUTION:
When installing the brake hose onto the
brake master cylinder make sure that the
brake pipe touches the projection a as
shown.
NOTE:
Turn the handlebar to the left and to the right to
make sure that the brake hose does not touch
other parts (e.g., wire harness, cables, leads).
Correct if necessary.
6-26
CHAS
AND INSTALLING
Recommended brake fluid
DOT 4
Brake master cylinder bolt
10 Nm (1.0 mSkg)
Union bolt
30 Nm (3.0 mSkg)
THE