Yamaha XJR1300(L) 99 Service Manual page 321

S Set the main switch to "ON".
S Set the turn signal switch to "
S Measure the voltage (12 V) of chocolate
or dark green at the turn signal light con-
2
nector (wire harness side).
S Is the voltage within specification?
YES
This circuit is OK.
EAS00800
4. The neutral indicator light fails to come on.
1. Neutral indicator light bulb and socket
S Check the neutral indicator light bulb and
socket for continuity.
Refer to "CHECKING THE BULBS AND
BULB SOCKETS".
S Are the neutral indicator light bulb and socket
OK?
YES
2. Neutral switch
S Check the neutral switch for continuity.
Refer to "CHECKING THE SWITCHES".
S Is the neutral switch OK?
YES
SIGNALING SYSTEM
" or " ".
1
NO
The wiring circuit
from the turn signal
switch to the turn sig-
nal light connector is
faulty and must re-
paired.
NO
Replace the neutral
indicator light bulb,
socket or both.
NO
Replace the neutral
switch.
EAS00760
3. Diode
S Disconnect the starting circuit cutoff relay
from the coupler.
S Connect the pocket tester (Ω
starting circuit cutoff relay terminals as
shown.
S Measure the starting circuit cutoff relay for
continuity as follows.
Tester positive probe !
light green
Tester negative probe !
Tester positive probe !
Tester negative probe !
light green
NOTE:
When you switch the "–" and "+" leads of the
digital pocket tester the readings in the above
chart will be reversed.
S Are the tester readings correct?
YES
7-37
ELEC
1) to the
1
Continuity
sky blue
2
No
sky blue
2
continuity
1
NO
Replace the relay
unit.