CHECKING AND CHARGING THE BATTERY/
CHECKING THE FUSES
6. Check:
S battery vent
Obstruction ! Clean.
Damage ! Replace.
7. Install:
S battery
8. Connect:
S battery leads
(to the battery terminals)
CAUTION:
First, connect the positive lead 1 , then the
negative lead 2 .
9. Check:
S battery terminals
Dirt ! Clean with a wire brush.
Loose connection ! Connect properly.
10. Lubricate:
S battery terminals
Recommended lubricant
11. Install:
S seat
EAS00181
CHECKING THE FUSES
The following procedure applies to all of the
fuses.
CAUTION:
To avoid a short circuit, always turn the main
switch to "OFF" when checking or replacing
a fuse.
1. Remove:
S seat
2. Check:
S fuse
a. Connect the pocket tester to the fuse and
check the continuity.
NOTE:
Set the pocket tester selector to "Ω x 1".
3-46
CHK
ADJ
Dielectric grease