FRONT FORK
EB703703
ASSEMBLING THE FRONT FORK LEGS
The following procedure applies to both of the
front fork legs.
WARNING
S Make sure that the oil levels in both front
fork legs are equal.
S Uneven oil levels can result in poor han-
dling and a loss of stability.
NOTE:
S When assembling the front fork leg, be sure to
replace the following parts:
-inner tube bushing
-outer tube bushing
-oil seal
-dust seal
S Before assembling the front fork leg, make
sure that all of the components are clean.
1. Install:
S damper rod 1
CAUTION:
Allow the damper rod to slide slowly down
the inner tube 2 until it protrudes from the
bottom of the inner tube. Be careful not to
damage the inner tube.
2. Lubricate:
S inner tube's outer surface
Recommended lubricant
Yamaha fork and shock oil 10W
or equivalent
3. Tighten:
S damper rod bolt 1
Damper rod bolt
30 Nm (3.0 mSkg)
LOCTITE
NOTE:
While holding the damper rod with the damper
rod holder 2 and T-handle 3 , tighten the
damper rod bolt.
Damper rod holder (30 mm)
90890-01327
T-handle
90890-01326
6-47
CHAS