Table of Contents
Advertisement
Offline Menus
Configuration Changes
You can change configuration settings from the drive offline menu system by using
the Menu and Select switches to navigate the offline menu system. You enter the
configuration or TCP/IP submenu when you press the Select switch while the main
menu item appears in the display. The first option in the submenu appears in the
display to confirm your selection.
There are three basic types of change mechanisms: toggles, options, and values.
A toggle is a choice between two values. An example is the DSE mode option where
you must choose between the choices of YES or NO. If YES appears in the display
and you wish the selection to be NO:
1. Press the Select switch.
2. Press the Menu switch to advance to the next menu item.
Options are similar to toggles, but you must choose among three or more values.
An example is the Compression mode option with choices of Yes, No, or OFF.
1. Press the Select switch until the desired choice appears in the display.
2. Press the Menu switch to advance to the next menu item.
A value is typically a numeral or a hexadecimal character.
Often you will change an address consisting of one or more characters.
1. Press the Select switch.
2. Press the Select switch to increment the value.
3. Press the Menu switch when the desired value appears in the display.
The adjacent character to the right flashes.
4. Repeat steps 1 through 3 to set the proper value for the second or
5. Press the Menu switch to advance to the next menu item.
The last menu item after a change is typically Save/IPL ?. Press the Select switch
to accept the change and start the drive IPL.
However, if you press the Menu switch, the display will typically advance to Exit
Menu ? Press Select to exit or Menu to return to the first item in the submenu.
56 T9840 URM
No appears in the display.
The left-most character of the value flashes.
The character stops flashing.
succeeding character. When you have set all characters, go to step 5.
Note – If you press the Select switch, the first character in the
value sequence flashes, and you can increment the value.
December 2012
Advertisement
Table of Contents
