Messages; Table 5-2 Operator Panel Display Messages - Oracle StorageTek T9840 User Manual

Messages

Messages
TABLE 5-2
actions.

TABLE 5-2 Operator Panel Display Messages

Display
* (asterisk) The tape drive is online but a cartridge tape
is not loaded.
IPL diagnostics are running.
ASIA Diags
Bank n Bad During boot, a section of memory was found
bad.
BldMIRFail Rebuild of Media Information Region (MIR)
unsuccessful.
Note: Code level 1.30.109 and higher displays
CHK XXXX.
The IPL failed.
Boot Fail
BT Monitor A sequence of switches accessed an
engineering area.
CC Diags IPL diagnostics are running.
CHK xxxx, An operational failure occurred; the tape
where xxxx drive might automatically perform an IPL
is an FSC depending on the operational mode of the
drive and the specific failure.
Cleaning A cleaning cartridge is in the tape drive and
(*Cleaning*) is now cleaning.
cnhndnsn The tape drive firmware level is insufficient
(Hardware to control the tape drive hardware.
revision level
supported by
the firmware in
this drive)
CodCrFail1 The tape drive cannot write code onto the
data cartridge tape, or the tape drive cannot
position the data cartridge tape.
CodCrFail2 The tape drive cannot read code from the
data cartridge tape.
CodeUpDate The firmware in the tape drive is being
updated from the host; the operator panel
switches are locked.
72 T9840 URM
lists operator panel display messages, meanings, and recommended
Meaning Recommended Action
Load a cartridge tape as required.
None
IPL the tape drive. If the problem
persists, place a service call.
IPL the tape drive again. If the
problem persists, place a service call.
IPL the tape drive. If the problem
persists, place a service call.
None
Wait for the IPL to complete and
retry the operation. If the problem
persists, place a service call.
See TABLE 5-3 on page 76
codes that are most often caused by
an operator error.
None
Place a service call.
Ensure that the tape is write-enabled,
or try another cartridge tape.
Retry the operation, or try another
cartridge tape. If the problem
persists, place a service call.
None
for a list of
December 2012