Oracle StorageTek T9840 User Manual page 74

Messages
TABLE 5-2 Operator Panel Display Messages (Continued)
Display
Init xxxx. An initialization error occurred.
where xxxx is
an FSC
IPL Pend The IPL switch has been pressed.
LOAD CC The common controller code is loading; IPL
is proceeding.
LOAD ESCON ESCON firmware is loading; IPL is
proceeding.
LOAD FIBRE Fibre Channel firmware is loading; IPL is
proceeding.
LOAD FICON FICON firmware is loading; IPL is
proceeding.
LOAD SERVO The servo code is loading; IPL is proceeding. None
LOAD SCSI SCSI firmware is loading; IPL is proceeding.
LOAD xxxx, The load or unload operation failed.
where xxxx is
an FSC
Loading A cartridge tape is loading.
Locating The tape drive is doing a high-speed seek.
Memory Err The IPL failed.
NTReady A A write-enabled VolSafe data cartridge is in
the process of a manual unload.
NTReady F A write-protected tape is in the process of a
manual unload.
NTReady U A write-enabled tape is in the process of a
manual unload.
The tape drive is offline.
Offline,
alternating
with *
Online The tape drive is online.
OnLn Pend The online state is pending completion of IPL
diagnostics.
Power Fail The power supply failed.
The tape drive is reading data.
Reading
74 T9840 URM
Meaning Recommended Action
Contact authorized service
personnel.
None
None
None
None
None
None
If the load failed, insert another
cartridge tape. If it loads successfully,
suspect the original tape. If another
tape fails to load, IPL the tape drive.
If the problem persists, contact your
service representative.
None
None
IPL the tape drive again. If the
problem persists, contact authorized
service personnel.
None
None
None
Perform offline menu operations or
exit the menu system.
None
None
Contact authorized service
personnel.
None
December 2012