Virtual Operator Panel - Oracle StorageTek T9840 User Manual

Virtual Operator Panel

Read Bar
As data is read from the tape, the read bar appears in the center of the write bar as a
single row of unlighted dots. This row is bordered above and below by single rows of
lighted dots. The read bar also begins at the left side of the display and advances to
the right. The point where the read bar ends is the percentage of tape that has been
read.
FIGURE 2-2 on page 35
tape that is 50% written and 34% read.
Virtual Operator Panel
The Virtual Operator Panel provides a graphical user interface to the T9840D tape
drive. The interface contains several menus, a set of indicators, two small display
areas, and a text pane (see
The Drive Operations menu provides commands to perform actions that are similar
to the physical operator panel switches.
The Retrieve and Configure menus provide commands to allow you to access
functions that are equivalent to the online and offline drive menu system.
FIGURE 2-3 Virtual Operator Panel
See the Virtual Operator Panel documentation for a description of the application.
36 T9840 URM
is a simplified and an actual view of a tape bar that shows a
FIGURE
Note – VOP version 1.0.13 or higher in conjunction with the
appropriate drive code level supports the use of an IPv6 address.
2-3).
December 2012