Table of Contents
Advertisement
This chapter discusses operator tasks primarily for desktop and rack-mounted tape
drives. Most of these tasks rely on the physical operator panel switches,
alphanumeric display, and the drive menu system.
Basic Tasks
•
"Power-on a Drive"
•
"Power-off a Drive" on page 60
•
"IPL the Drive" on page 60
▼ Power-on a Drive
To apply power to the desktop or rack-mount configuration:
1. Make sure the power cord is connected from the receptacle on the chassis rear
panel to an AC power outlet or power strip.
2. Make sure that all interface cables are fully seated.
3. Set the power switch on the back of the drive or the rear panel to on (|).
The drive(s) will power-on and perform an initial program load (IPL).
• The drive power indicator flashes.
• Various messages relative to the IPL sequence appear in the operator panel
display window. These messages do not require any action from you.
The drive successfully completes an IPL when:
December 2012
Note – For operator tasks relating to drives within a library,
consult the appropriate library operator guide. The scope of tasks
documented depends on the functionality of the particular library.
Library information might describe only drive cleaning or provide
a broad range of tasks (using the drive operator panel, cleaning a
drive, and manually mounting or dismounting a cartridge).
• The drive power indicator is steady.
• An asterisk (*) appears in the operator panel display window.
Operator Tasks
Operator Tasks 59
4
Advertisement
Table of Contents
