Preparing The Two-Post Telco Rack - Sun Microsystems StorageTek 6140 Array Release Notes

C
C H A P T E R

Preparing the Two-Post Telco Rack

Use the procedures in this chapter to install trays in a standard Telco rack. (You can
use the existing universal rack kit and procedures to install the Sun StorageTek 6140
array in a four-post Telco rack.) The number of trays you need to install depends on
your overall storage requirements. You can install a maximum of eight, one
controller tray and up to seven expansion trays, in a third-party Telco rack.
This chapter describes the process of installing Sun StorEdge 6140 trays. It contains
the following sections:
"Preparing the Telco Rack" on page 50
■
"Attaching the Rails to a Telco 2-Post Rack" on page 50
■
"Installing a Tray in a Telco 2-Post Rack" on page 55
■
The installation procedures in this chapter require the following items:
#2 Phillips screwdriver
■
#3 Phillips screwdriver
■
Flathead screwdriver
■
Antistatic protection
■
Caution – Electrostatic discharge can damage sensitive components. Touching the
array or its components without using a proper ground might damage the
equipment. To avoid damage, use proper antistatic protection before handling any
components.
49