Unpacking The Blackdiamond 8806 Chassis; Installing The Blackdiamond 8800 Series Chassis - Extreme Networks BlackDiamond 8806 Hardware Installation Manual

Installing the BlackDiamond 8800 Series Chassis

Unpacking the BlackDiamond 8806 Chassis

NOTE
Do not remove the nylon straps until you are ready to open the chassis package.
CAUTION
The BlackDiamond 8806 chassis weighs almost 65 pounds. Proper lifting and moving of the chassis requires two
people.
To unpack the BlackDiamond 8806 chassis:
1 Remove the nylon straps from around the shipping carton.
2 Open the top flaps and remove the accessories and documentation pack from the shipping carton
(see Figure
Figure 44: Removing Accessories from the BlackDiamond 8806 Chassis Shipping Carton
19-inch helper bracket
3 Release the clip locks (see
a Place your thumb and index finger inside the clip lock to grasp the prongs.
b Squeeze the prongs inward, applying equal pressure on each side.
c Pull the prongs outward until the clip lock is released from the carton.
Repeat these steps to release each remaining clip lock.
82
44). Lift out the packing foam.
Figure 45).
Power cord retaining bracket
BlackDiamond documentation pack
with ESD-preventive wrist strap
BlackDiamond 8800 Series Switches Hardware Installation Guide
EX_110