Gbic, Sfp (Mini-Gbic), Xenpak, And Xfp Regulatory Compliance - Extreme Networks BlackDiamond 8806 Hardware Installation Manual

WARNING!
When working with laser optic modules, always take the following precautions to avoid exposure to hazardous
radiation.
●
Never look at the transmit LED/laser through a magnifying device while it is powered on.
●
Never look directly at a fiber port on the switch or at the ends of a fiber cable when they are powered on.
●
Invisible laser radiation can occur when the connectors are open. Avoid direct eye exposure to the beam
when optical connections are unplugged.
● Never alter, modify, or change an optical device in any way other than suggested in this document.

GBIC, SFP (Mini-GBIC), XENPAK, and XFP Regulatory Compliance

Extreme Networks pluggable optical modules meet the following regulatory requirements:
Class 1 Laser Product
●
EN60825-1+A2:2001 or later, European laser standard
●
FCC 21 CFR Chapter 1, Subchapter J in accordance with FDA & CDRH requirements
●
Application of CE Mark in accordance with 89/336/EEC EMC and 73/23/EEC Low Voltage
●
Directives
UL and/or CSA registered component for North America
●
47 CFR Part 15, Class A when installed into Extreme products
●
NOTE
Extreme Networks optical modules are tested to work in all supported Extreme Networks switches. We recommend
that all customers use Extreme Networks optical modules in their Extreme Networks switches. Extreme Networks
assumes no liability for third-party optical modules. Although Extreme Networks does not block third-party optical
modules, we cannot ensure that all third-party optical modules operate properly in all Extreme Networks switches.
The customer assumes all risks associated with using third-party optical modules in Extreme Networks switches.
BlackDiamond 8800 Series Switches Hardware Installation Guide
175