Extreme Networks BlackDiamond 8806 Hardware Installation Manual page 102

Installing Power Supply Units in the BlackDiamond 8800 Series Switches
Figure 61: Inserting an AC PSU into the Power Supply Bay
4 Secure the AC PSU in the power supply bay by pushing down on the locking handle until it clicks
into place.
5 If you are replacing a power supply, you do not need to unplug the AC power cord. For a newly
installed power supply, connect the AC power supply cord:
a If necessary, remove the power cord retainer as described in
Power Cord Retainers."
b Connect the new AC power cord to the AC input on the front of the switch and to the wall outlet
on the other end. Then re-install the power cord retainer.
c Re-install the power cord retainer as described in
Retainers."
To install additional Extreme Networks AC PSUs, repeat steps
NOTE
Leave the ESD strap permanently connected to the switch, so that the strap is always available when you need to
handle ESD-sensitive components.
102
EX_174
Chapter 3, "BlackDiamond AC
Chapter 3, "BlackDiamond AC Power Cord
2 through 5.
BlackDiamond 8800 Series Switches Hardware Installation Guide