Installing The Blackdiamond 8806 Psu Cover - Extreme Networks BlackDiamond 8806 Hardware Installation Manual

BlackDiamond PSU Covers

Installing the BlackDiamond 8806 PSU Cover

To install the PSU cover:
1 If necessary, remove the installed AC cord retainer.
2 Make sure that all required AC power cords are connected to the AC input connectors on the switch.
3 Attach the AC power cord retainer to the switch:
a Place the retainer against the front of the switch as shown in
retainer engages all the power cord connectors.
b Align and tighten the captive retaining screws.
Figure 97: Attaching the AC Cord Retainer
1
1 = Captive retaining screw
4 Set the feet on the base of the cover into the square openings on the top of the AC cord retainer
(Figure 98).
Figure 98: Setting the PSU Cover in Place
140
Figure 97. Make sure that the
BlackDiamond 8800 Series Switches Hardware Installation Guide
EX_186
EX_187