Installing the BlackDiamond 12800 Series Chassis
Unpacking the BlackDiamond 12804 Chassis
NOTE
Do not remove the nylon straps until you are ready to open the chassis package.
To unpack the BlackDiamond 12804 chassis:
1 Remove the nylon straps from around the shipping carton.
2 Open the top flaps and remove the accessories and documentation pack from the shipping carton
(see
Figure
Figure 26: Removing Accessories from the BlackDiamond 12804 Chassis Shipping Carton
19-inch helper bracket
3 Release the clip locks (see
a Place your thumb and index finger inside the clip lock to grasp the prongs.
b Squeeze the prongs inward, applying equal pressure on each side.
c Pull the prongs outward until the clip lock is released from the carton.
Repeat these steps to release each of the remaining clip locks.
58
26). Lift out the packing foam.
Figure
27).
Power cord retaining bracket
BlackDiamond documentation pack
with ESD-preventive wrist strap
BlackDiamond 12800 Series Switches Hardware Installation Guide
EX_110