Installing Cable - Extreme Networks BlackDiamond 8806 Hardware Installation Manual

Installing Cable

Consider the following recommendations when you connect cable to your network equipment:
Examine cable for cuts, bends, and nicks.
●
Support cable using a cable manager that is mounted above connectors to avoid unnecessary weight
●
on the cable bundles.
Use cable managers to route cable bundles to the left and right of the network equipment to
●
maximize accessibility to the connectors.
Provide enough slack, approximately 2 to 3 inches (5.08 to 7.62 cm), to provide proper strain relief as
●
shown in Figure 42.
Bundle cable using velcro straps to avoid injuring cables.
●
If you build your own cable, be sure that cable is properly crimped.
●
When installing a patch panel using twisted pair wiring, untwist no more than 1 inch (2.54 cm) of
●
the cable to avoid radio frequency (RF) interference.
Discharge the RJ-45 Ethernet cable before plugging it into a port on the switch.
●
Use plenum-rated cable when it is necessary for safety and fire rating requirements. Consult your
●
local building codes to determine when it is appropriate to use plenum-rated cable, or refer to IEC
standard 850.
Keep all ports and connectors free of dust.
●
CAUTION
Unshielded twisted pair (UTP) cable can build up ESD charges when being pulled into a new installation. Before
connecting any category 5 UTP cable to the switch, discharge ESD from the cable by plugging the RJ-45 connector
into a LAN Static Discharge device or use an equivalent method.
BlackDiamond 8800 Series Switches Hardware Installation Guide
75