APRILIA RSV 1000 R Factory Use And Maintenance Book page 26

2
To set the red line threshold:
◆
Turn the ignition key to "
◆
Allow some time for the dashboard
check-up routine.
◆
Hold down the "Trip/V" button for at least
three seconds: the rev counter pointer
(2) will point the current red line setting.
◆
You have three seconds to change
setting as desired (as long as the rev
counter pointer (2) is pointing current red
line setting).
◆
Use the "+" button to change setting.
Press briefly to increase setting by 100
rpm. Hold down a little longer to increase
by 1000 rpm.
◆
After reaching full scale value (12,000
rpm), the pointer will go back to zero
automatically.
use and maintenance RSV 1000 R - RSV 1000 R FACTORY
26
2
◆
Three seconds after last pressing the "+"
button, the new red line threshold is
".
stored. This is confirmed by the red line
light (1) coming on for three seconds,
while the pointer (2) will go back to zero.
◆
If the engine is started during the setting
procedure, the last setting is retained.
The new threshold setting is also lost if
the battery is disconnected during the
setting procedure, and the last setting is
retained.
1
1