Door Gasket Relacement - PSG Caddy PF01010 Installation And Operating Instructions Manual

5.6 DOOR GASKET RELACEMENT

It is important to keep the door gasket in good condition. The door is adjusted at
the factory to seal the door tight. After a while, the gasket could sink and the door
must then be adjusted as described below. If the door still leaks after the
maximum adjustment, replace the gasket (see Section 6.2, THE DOOR
GASKET.)
Door adjustment procedure:
1. Unscrew completely the locking pin with its nut (see picture below).
2. To increase the pressure of the door on the gasket, turn the handle counter
clockwise; to decrease the pressure of the door on the gasket, turn the handle
clockwise until desired pressure is attained.
3. Then, screw back the locking pin about 1/4" deep and make sure you lock it in
place with the nut.
LOCKING PIN
88