Heating; First Signs Of An Overheating Furnace Are; Wood As A Combustible - PSG Caddy PF01010 Installation And Operating Instructions Manual

Table of Contents

Advertisement

4.3 HEATING

1. Poke the fire and spread the embers evenly at the center of the combustion
chamber before adding more wood.
2. Avoid overfilling the combustion chamber; air must be allowed to circulate
freely through the upper portion of the chamber for the stove to perform best.
Also remember that a small hot fire burns cleaner than a big smoldering one.
WHEN RELOADING, MAKE SURE YOU KEEP THE AIR INLETS LOCATED
BELOW THE DOOR INSIDE THE COMBUSTION CHAMBER FREE OF ASH.
OPENING PROCEDURE FOR THE LOADING DOOR
TO MINIMISE THE RISK OF SMOKE SPILLAGE, CRACK THE DOOR OPEN
ABOUT AN INCH AND WAIT ABOUT 10 SECONDS BEFORE OPENING IT
WIDE TO ALLOW STABILISATION OF THE PRESSURE INSIDE THE
FURNACE.

4.4 FIRST SIGNS OF AN OVERHEATING FURNACE ARE:

1. The fire rumbles.
2. The smoke pipe turns red.
3. Extreme heat emanates from the furnace. IF this happens, DO NOT OPEN
THE DOOR, close the air inlet completely and wait for the fire to die down.
ALWAYS KEEP THE DOOR AND ASH DRAWER CLOSED EXCEPT FOR
LIGHTING, RELOADING AND SERVICING THE FURNACE
4.5

WOOD AS A COMBUSTIBLE

NEVER BURN GARBAGE, GASOLINE, NAPHTA, MOTOR OIL OR ANY
SIMILAR FLAMMABLE PRODUCTS IN THIS FURNACE.
We recommend that you only burn well seasoned cordwood in your furnace.
Two important factors should be considered when buying cordwood; water
content and density of the wood. Hard wood like oak, maple or beech give better
results given their higher density and the less tar they produce during
IMPORTANT
WARNING
WARNING
82

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents