Caddy Wood Only Furnace; Necessary Components For Caddy Wood Only Furnace; Appliance Installation; Unit Location - PSG Caddy PF01010 Installation And Operating Instructions Manual

3.2  CADDY WOOD ONLY FURNACE

3.2.1 NECESSARY COMPONENTS FOR CADDY WOOD ONLY FURNACE

To use the configuration of the Caddy wood only furnace you have to assemble
the blower assembly and fan limit control (PA08568), sold separately. The
assembly instructions are in the instruction manual supplied with the blower
assembly kit.

3.2.2 APPLIANCE INSTALLATION

3.2.2.1 UNIT LOCATION

The furnace must be installed where outside air supply will be sufficient for
proper combustion. In airtight houses, it might be necessary to install an outside
air inlet (see details in Section 2.12.)
The furnace must be positioned so that the connector is as short as possible.
o
Minimize the use of 90 elbows.
The owner must ensure a proper installation to allow a safe operation of
the appliance.

3.2.2.2 PARALLEL INSTALLATION

Parallel installation with another furnace that shares the same ducts system is
not permitted in Canada. That type of installation is permitted in the USA
only. In parallel installation, the maximum heat input of the existing gas, oil or
electric furnace should be equal or superior to that of the wood furnace. Duct
clearances must be respected as if the wood furnace was installed by itself.
Necessary adjustments must be made to the distribution ducts so as to maintain
static pressure between 0.20 and 0.05 in W.C. A back flow damper must be
installed in order to make sure that the hot air circulates to the house and does
not flow back through the plenum of the unused furnace. Depending on the type
of installation, a damper may have to be installed in the plenum of both furnaces.
39