Adjust The Volume - CyberData 011123x Operation Manual

2.2.6.2 Restoring the Factory Default Settings
When troubleshooting configuration problems, it is sometimes convenient to restore the device to a
known state.
Note
To restore the factory default settings:
1. Press and hold the RTFM button (SW1) for more than five seconds.
2. The device announces that it is restoring the factory default settings.
Note

2.2.7 Adjust the Volume

You can adjust the volume through the
Operations Guide
Each Intercom is delivered with factory set default values.
The device will use DHCP to obtain the new IP address (DHCP-assigned address or default
to 10.10.10.10 if a DHCP server is not present).
930370N
Installing the VoIP Indoor Intercom with Keypad (Flush-Mounted)
Figure 2-9. RTFM Button
Device Configuration Page.
Parts List
RTFM
CyberData Corporation
17